"$ifapplyAugerofT" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "$ifapplyAugerofT is to enable the temperature-dependent Auger coefficient module with the predefined function. The function is designed for each region. So if total...") |
(無差異)
|
於 2021年6月9日 (三) 09:36 的最新修訂
$ifapplyAugerofT is to enable the temperature-dependent Auger coefficient module with the predefined function. The function is designed for each region. So if total n regions are used, then you will need to set up n regions. The format is
$ifapplyAugerofT p1 p2 p3 p1 p2 p3 p1 p2 p3 ... ... ... p1 p2 p3
p1: AugerC at 300K
