"$negfsectionarea" 修訂間的差異
出自 DDCC TCAD TOOL Manual
| (未顯示同一使用者於中間所作的 5 次修訂) | |||
| 行 1： | 行 1： | ||
| − | $negfsectionarea is the command to setup the area of cross section for transport direction.The unit is m^2.<br> |
+ | $negfsectionarea is the command to setup the area of cross section for transport direction.The unit is m^2. You can also use this function and set the parameter with our GUI version at the input box of "Cross Area" in GUI<br> |
| + | |||
| + | $negfsectionarea |
||
| + | cross_section_area_of_the_device |
||
Example: |
Example: |
||
$negfsectionarea |
$negfsectionarea |
||
8.042e-16 |
8.042e-16 |
||
| + | related commands: |
||
| + | [[$ifsolvenegf]] |
||
於 2019年6月18日 (二) 01:10 的最新修訂
$negfsectionarea is the command to setup the area of cross section for transport direction.The unit is m^2. You can also use this function and set the parameter with our GUI version at the input box of "Cross Area" in GUI
$negfsectionarea cross_section_area_of_the_device
Example:
$negfsectionarea 8.042e-16
related commands:
$ifsolvenegf
