$Thermalcoe

$Thermalcoe is the command to setup the thermal related coefficients. The command is as following

If we have N volumes, the input format would be  

$Thermalcoe
Volume_num_1  kappa_1  heat_source
Volume_num_2  kappa_2  heat_source
...
...
... 
...
 Volume_num_N  kappa_N  heat_source

 Volume_num  Mesh volume number
 kappa thermal conductive coefficient, unit cgs  $W/(cm^{2} \cdot K)$
 heat_source: heat source, the unit is  $Joul/s/cm^{3}$ or $W/cm^{3}$

related commands

$Thermalcoe, $Boundary, $ifsolveheat