$usedynaohmic
出自 DDCC TCAD TOOL Manual
於 2017年12月4日 (一) 14:29 由 Yrwu (對話 | 貢獻) 所做的修訂 (已建立頁面，內容為 "$usedynaohmic is the command to ask the program to find the fermi-level of contact point to make it as ohmic or Schottky according to the doping. If this command is...")
$usedynaohmic is the command to ask the program to find the fermi-level of contact point to make it as ohmic or Schottky according to the doping. If this command is activated, the program will try to find the ohmic contact setting of drain and source. But the contact is not included. The command to activate this is:
$usedynaohmic
