"$Boundary" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "$Boundary or $ThermalBoundary are the same commands. This command setup the thermal boundary of 3D thermal solver. The format is $Boundary N_surface_number...") |
|||
| 行 1： | 行 1： | ||
| − | $Boundary |
+ | [[$Boundary]] orand [[$ThermalBoundary]] are the same commands. This command setup the thermal boundary of 3D thermal solver. The format is |
$Boundary |
$Boundary |
||
| 行 9： | 行 9： | ||
..... |
..... |
||
..... repeat N_surface_number |
..... repeat N_surface_number |
||
| + | |||
| + | Surface_No: The gmsh surface number to set as thermal boundary |
||
| + | Surface_type: value: 1: fix temperature boundary 2: convention boundary condition |
||
| + | Surface_value: The coefficient at the boundary. For type 1, it is the surface potential For type=2, it is the thermal convention coeffcient |
||
| + | |||
| + | For example |
||
| + | $Boundary |
||
| + | 3 |
||
| + | 123 1 300.0 |
||
| + | 221 1 400.0 |
||
| + | 224 2 22.3 |
||
| + | |||
| + | Related links |
||
| + | [[$Boundary]] , [[$ThermalBoundary]] |
||
於 2018年7月17日 (二) 15:57 的修訂
$Boundary orand $ThermalBoundary are the same commands. This command setup the thermal boundary of 3D thermal solver. The format is
$Boundary N_surface_number Surface_No_1 Surface_type Surface_value Surface_No_1 Surface_type Surface_value Surface_No_1 Surface_type Surface_value Surface_No_1 Surface_type Surface_value ..... ..... repeat N_surface_number
Surface_No: The gmsh surface number to set as thermal boundary Surface_type: value: 1: fix temperature boundary 2: convention boundary condition Surface_value: The coefficient at the boundary. For type 1, it is the surface potential For type=2, it is the thermal convention coeffcient
For example
$Boundary 3 123 1 300.0 221 1 400.0 224 2 22.3
Related links
$Boundary , $ThermalBoundary
