"$Boundary" 修訂間的差異

出自 DDCC TCAD TOOL Manual
前往: 導覽搜尋
 
行 22: 行 22:
   
 
Related links
 
Related links
[[$Boundary]] , [[$ThermalBoundary]], [[$ifsolveheat]]
+
[[$Boundary]] , [[$ThermalBoundary]], [[$ifsolveheat]], [[$Thermalcoe]]

於 2018年7月17日 (二) 16:22 的最新修訂

$Boundary orand $ThermalBoundary are the same commands. This command setup the thermal boundary of 3D thermal solver. The format is

$Boundary
N_surface_number
Surface_No_1  Surface_type  Surface_value
Surface_No_1  Surface_type  Surface_value
Surface_No_1  Surface_type  Surface_value
Surface_No_1  Surface_type  Surface_value
.....
.....  repeat N_surface_number
Surface_No: The gmsh surface number to set as thermal boundary
Surface_type:  value: 1: fix temperature boundary  2: convention boundary condition
Surface_value: The coefficient at the boundary. For type 1, it is the surface potential  For type=2, it is the thermal convention coeffcient

For example

$Boundary
3
123  1  300.0
221  1  400.0
224  2  22.3

Related links

 $Boundary , $ThermalBoundary, $ifsolveheat, $Thermalcoe