"$RCWAxdiv" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面,內容為 "The $RCWAxdiv command is used to set material boundary number in each layer. It also needs to goes with the $RCWAxnode and $RCWAperiod to define position of...") |
|||
(未顯示同一使用者於中間所作的 3 次修訂) | |||
行 1: | 行 1: | ||
− | The $RCWAxdiv command is used to set material boundary number in each layer. It also needs to goes with the [[$RCWAxnode]] and [[$RCWAperiod]] to define position of boundary point and the period of simulation domain. |
+ | The $RCWAxdiv command is used to set material boundary number in each layer. It also needs to goes with the [[$RCWAxnode]] and [[$RCWAperiod]] to define position of boundary point and the period of simulation domain. The left boundary point does not need to assign. |
+ | [[檔案:RCWA2D_input.jpg]] |
||
+ | $RCWAxdiv<br> |
||
+ | 3 |
||
+ | 3 |
||
+ | 5 |
||
+ | 3 |
||
+ | 3 |
||
+ | ... |
||
+ | total layer |
於 2020年6月16日 (二) 10:22 的最新修訂
The $RCWAxdiv command is used to set material boundary number in each layer. It also needs to goes with the $RCWAxnode and $RCWAperiod to define position of boundary point and the period of simulation domain. The left boundary point does not need to assign.
$RCWAxdiv
3 3 5 3 3 ... total layer