"$SourcePosition" 修訂間的差異

出自 DDCC TCAD TOOL Manual
前往: 導覽搜尋
(Format)
行 12: 行 12:
 
1~4: you only need ''pt<sub>1</sub>'' to define the position, ''axis'' decides which surface is used.
 
1~4: you only need ''pt<sub>1</sub>'' to define the position, ''axis'' decides which surface is used.
 
11~14: similar to 1~4, but ''dir'' decides which direction the wave propagates.
 
11~14: similar to 1~4, but ''dir'' decides which direction the wave propagates.
21~24: ''pt<sub>1~6</sub>'' are x-, x+, y-, y+, z-, and z+. This tell the program where the total field is.
+
21~24: ''pt<sub>1~6</sub>'' are x-, x+, y-, y+, z-, and z+. This tells the program where the total field is.
 
31~34: ''pt<sub>1~6</sub>'' are x-, x+, y-, y+, z-, and z+. (not finished)
 
31~34: ''pt<sub>1~6</sub>'' are x-, x+, y-, y+, z-, and z+. (not finished)
 
51~64: ''pt<sub>2,4,6</sub>'' are x, y, and z. Define which point is the source.
 
51~64: ''pt<sub>2,4,6</sub>'' are x, y, and z. Define which point is the source.

於 2019年8月14日 (三) 14:23 的修訂

Format

$SourcePosition
 pt1    pt2    pt3    pt4    pt5    pt6                // all are floating points.

Define the source area.

If it is not any node at the pt, the program will find the nearest point/face as the source.

 When the type of source in $SourceType is 
 1~4: you only need pt1 to define the position, axis decides which surface is used.
 11~14: similar to 1~4, but dir decides which direction the wave propagates.
 21~24: pt1~6 are x-, x+, y-, y+, z-, and z+. This tells the program where the total field is.
 31~34: pt1~6 are x-, x+, y-, y+, z-, and z+. (not finished)
 51~64: pt2,4,6 are x, y, and z. Define which point is the source.

Example

$SourcePosition
 700e-9    0    0    0    0    0

Related commands

$SourceType, $SourceAmp, $SourcePosition, $SourceFrequency