$basebias
出自 DDCC TCAD TOOL Manual
於 2017年8月21日 (一) 10:51 由 Yrwu (對話 | 貢獻) 所做的修訂 (已建立頁面,內容為 "$basebias is to determine the additional bias in the simulation. It is similar to the $sourcebias, where is a fixed value is used. This is for the system that h...")
$basebias is to determine the additional bias in the simulation.
It is similar to the $sourcebias, where is a fixed value is used. This is for the system that has 4 or more contacts.
For example
$basebias 0.1
This means that the bias of the base contact is at 0.1V.