"$emptyperiodshape" 修訂間的差異
出自 DDCC TCAD TOOL Manual
Jameshuang (對話 | 貢獻) |
Jameshuang (對話 | 貢獻) |
||
| 行 33： | 行 33： | ||
Type.5 and 6 can be determined by this expression: |
Type.5 and 6 can be determined by this expression: |
||
| − | <math>f_6<y< |
+ | <math>f_6<y<f_1sin(f_2x)+f_3;</math><br /> |
<math>f_4<x<f_5</math> |
<math>f_4<x<f_5</math> |
||
| 行 39： | 行 39： | ||
Type.7 and 8 can be determined by this expression: |
Type.7 and 8 can be determined by this expression: |
||
| − | <math>f_6<x< |
+ | <math>f_6<x<f_1sin(f_2y)+f_3;</math><br /> |
<math>f_4<y<f_5</math> |
<math>f_4<y<f_5</math> |
||
於 2017年8月28日 (一) 09:18 的最新修訂
$emptyperiodshape is a function that you can set difference empty shape for period. It is the same as $emptyperiodtriangle
Format
$emptyperiodshape n type1 f1 f2 f3 f4 f5 f6 int_period_num f_period_spacing
Parameter Explanation
- n : number of empty section.
- type : type1=triangle, type2=circle, type3=ellipse, type4=rectangular, type5=Sinkx function up, type6=Sinkx function down, type7=Sinkx function up, type8=Sinkx function down.
- f1-f6 : you can refer to the information where at bottom of this page.
- int_period_num :
- f_period_spacing :
Example
Type.1~4 are triangle, circle, ellipse and rectangle.
If the parameters are not show in the figure, you should set those parameters as 0.
Type5~8 are sine shape period structure.
Type.5 and 6 can be determined by this expression:
Type.7 and 8 can be determined by this expression:
