"$heatsolvebytime" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "$heatsolvebytime or $heatsolvebyt is the command to solve the time dependent thermal dissipation equations. The command line format is <br> $heatsolvebytime<br> <ma...") |
|||
| 行 1： | 行 1： | ||
$heatsolvebytime or $heatsolvebyt is the command to solve the time dependent thermal dissipation equations. The command line format is <br> |
$heatsolvebytime or $heatsolvebyt is the command to solve the time dependent thermal dissipation equations. The command line format is <br> |
||
| − | $heatsolvebytime<br> |
+ | $heatsolvebytime<br> |
| − | <math>\delta t</math> |
+ | <math>\delta t</math> N_of_dt reference_temperature N_step_to_save |
| + | |||
| + | <math>\delta t</math> is the dt used for transient calculation. <br> |
||
| + | N_of_dt are the steps to solve these equations<br> |
||
| + | reference_temperature is the reference initial temperature. Usually it would be room temperature. <br> |
||
| + | "N_step_to_save" is to output the result every "N_step_to_save"<br> |
||
| + | |||
| + | Examples:<br> |
||
| + | $heatsolvebytime |
||
| + | 1.000e-7 1000 300.00 100 |
||
| + | |||
| + | related commands:<br> |
||
於 2017年8月22日 (二) 23:36 的修訂
$heatsolvebytime or $heatsolvebyt is the command to solve the time dependent thermal dissipation equations. The command line format is
$heatsolvebytime
N_of_dt reference_temperature N_step_to_save
is the dt used for transient calculation.
N_of_dt are the steps to solve these equations
reference_temperature is the reference initial temperature. Usually it would be room temperature.
"N_step_to_save" is to output the result every "N_step_to_save"
Examples:
$heatsolvebytime 1.000e-7 1000 300.00 100
related commands:
