"$ifelectrode" 修訂間的差異

出自 DDCC TCAD TOOL Manual
前往: 導覽搜尋
 
行 28: 行 28:
 
End For
 
End For
 
End For
 
End For
  +
  +
related commands
  +
[[$schottkyba]], [[$ifelectrode]] , [[$ElBoundary]], [[$extraElBoundary]], [[$extraElBoundaries]]

於 2018年7月17日 (二) 16:54 的最新修訂

$ifelectrode is the command to setup the bias operation range. In the program, there are 4 types of electrical contacts, which are gate, drain, source, and base contact. The command is as following: The sweeping of base is disabled. So vbend and vbstep are useless.


$ifelectrode
vgstart, vgend, vgstep
vdstart, vdend, vdstep
vsstart, vsend, vsstep
vbstart, vbend, vbstep


For example


$ifelectrode
2.0  3.0  1.0 
4.0  -1.0 -0.2
1.0  2.0 0.01
0.0  0.0 0.01

The program will sweep from following loop

 For vg=vgstart,vgstep, vgend
   For vd=vdstart,vdstep, vdend
     For vs=vsstart,vsstep, vsend
           Solve Poisson, drift-diffusion, landscape equations
     End For
   End For
 End For

related commands

$schottkyba, $ifelectrode , $ElBoundary, $extraElBoundary, $extraElBoundaries