檢視 $ifelectrode 的原始碼

$ifelectrode is the command to setup the bias operation range. In the program, there are 4 types of electrical contacts, which are gate, drain, source, and base contact. The command is as following: The sweeping of base is disabled. So vbend and vbstep are useless. 



 $ifelectrode
 vgstart, vgend, vgstep
 vdstart, vdend, vdstep
 vsstart, vsend, vsstep
 vbstart, vbend, vbstep


 For example



 $ifelectrode
 2.0  3.0  1.0 
 4.0  -1.0 -0.2
 1.0  2.0 0.01
 0.0  0.0 0.01

The program will sweep from following loop
  For vg=vgstart,vgstep, vgend
    For vd=vdstart,vdstep, vdend
      For vs=vsstart,vsstep, vsend
            Solve Poisson, drift-diffusion, landscape equations
      End For
    End For
  End For

related commands
 [[$schottkyba]], [[$ifelectrode]] , [[$ElBoundary]], [[$extraElBoundary]], [[$extraElBoundaries]]