「$Boundary」：修訂間差異
跳至導覽
跳至搜尋
已建立頁面，內容為 "$Boundary or $ThermalBoundary are the same commands. This command setup the thermal boundary of 3D thermal solver. The format is $Boundary N_surface_number..." |
無編輯摘要 |
||
| 第1行： | 第1行： | ||
$Boundary | [[$Boundary]] orand [[$ThermalBoundary]] are the same commands. This command setup the thermal boundary of 3D thermal solver. The format is | ||
$Boundary | $Boundary | ||
| 第9行： | 第9行： | ||
..... | ..... | ||
..... repeat N_surface_number | ..... repeat N_surface_number | ||
Surface_No: The gmsh surface number to set as thermal boundary | |||
Surface_type: value: 1: fix temperature boundary 2: convention boundary condition | |||
Surface_value: The coefficient at the boundary. For type 1, it is the surface potential For type=2, it is the thermal convention coeffcient | |||
For example | |||
$Boundary | |||
3 | |||
123 1 300.0 | |||
221 1 400.0 | |||
224 2 22.3 | |||
Related links | |||
[[$Boundary]] , [[$ThermalBoundary]] | |||
於 2018年7月17日 (二) 07:57 的修訂
$Boundary orand $ThermalBoundary are the same commands. This command setup the thermal boundary of 3D thermal solver. The format is
$Boundary N_surface_number Surface_No_1 Surface_type Surface_value Surface_No_1 Surface_type Surface_value Surface_No_1 Surface_type Surface_value Surface_No_1 Surface_type Surface_value ..... ..... repeat N_surface_number
Surface_No: The gmsh surface number to set as thermal boundary Surface_type: value: 1: fix temperature boundary 2: convention boundary condition Surface_value: The coefficient at the boundary. For type 1, it is the surface potential For type=2, it is the thermal convention coeffcient
For example
$Boundary 3 123 1 300.0 221 1 400.0 224 2 22.3
Related links
$Boundary , $ThermalBoundary