"$Thermalcoe" 修訂間的差異
出自 DDCC TCAD TOOL Manual
| (未顯示同一使用者於中間所作的 1 次修訂) | |||
| 行 12： | 行 12： | ||
Volume_num Mesh volume number |
Volume_num Mesh volume number |
||
| − | kappa thermal conductive coefficient, unit cgs <math> W/(cm^{2} |
+ | kappa thermal conductive coefficient, unit cgs <math> W/(cm^{2} \cdot K)</math> |
heat_source: heat source, the unit is <math> Joul/s/cm^{3} </math> or <math>W/cm^{3}</math> |
heat_source: heat source, the unit is <math> Joul/s/cm^{3} </math> or <math>W/cm^{3}</math> |
||
related commands |
related commands |
||
| − | [[$Thermalcoe]], [[$Boundary]] |
+ | [[$Thermalcoe]], [[$Boundary]], [[$ifsolveheat]] |
於 2018年7月17日 (二) 16:21 的最新修訂
$Thermalcoe is the command to setup the thermal related coefficients. The command is as following
If we have N volumes, the input format would be
$Thermalcoe Volume_num_1 kappa_1 heat_source Volume_num_2 kappa_2 heat_source ... ... ... ... Volume_num_N kappa_N heat_source
Volume_num Mesh volume number kappa thermal conductive coefficient, unit cgsheat_source: heat source, the unit is
or
related commands
$Thermalcoe, $Boundary, $ifsolveheat
