「$ifelectrode」：修訂間差異
跳至導覽
跳至搜尋
已建立頁面，內容為 "$ifelectrode is the command to setup the bias operation range. In the program, there are 4 types of electrical contacts, which are gate, drain, source, and base cont..." |
無編輯摘要 |
||
| 第1行： | 第1行： | ||
$ifelectrode is the command to setup the bias operation range. In the program, there are 4 types of electrical contacts, which are gate, drain, source, and base contact. The command is as following | $ifelectrode is the command to setup the bias operation range. In the program, there are 4 types of electrical contacts, which are gate, drain, source, and base contact. The command is as following: The sweeping of base is disabled. So vbend and vbstep are useless. | ||
| 第8行： | 第8行： | ||
vsstart, vsend, vsstep | vsstart, vsend, vsstep | ||
vbstart, vbend, vbstep | vbstart, vbend, vbstep | ||
For example | |||
$ifelectrode | |||
2.0 3.0 1.0 | |||
4.0 -1.0 -0.2 | |||
1.0 2.0 0.01 | |||
0.0 0.0 0.01 | |||
The program will sweep from following loop | |||
For vg=vgstart,vgstep, vgend | |||
For vd=vdstart,vdstep, vdend | |||
For vs=vsstart,vsstep, vsend | |||
End For | |||
End For | |||
End For | |||
於 2018年7月17日 (二) 08:53 的修訂
$ifelectrode is the command to setup the bias operation range. In the program, there are 4 types of electrical contacts, which are gate, drain, source, and base contact. The command is as following: The sweeping of base is disabled. So vbend and vbstep are useless.
$ifelectrode vgstart, vgend, vgstep vdstart, vdend, vdstep vsstart, vsend, vsstep vbstart, vbend, vbstep
For example
$ifelectrode 2.0 3.0 1.0 4.0 -1.0 -0.2 1.0 2.0 0.01 0.0 0.0 0.01
The program will sweep from following loop
For vg=vgstart,vgstep, vgend
For vd=vdstart,vdstep, vdend
For vs=vsstart,vsstep, vsend
End For End For End For