"$RCWAxnode" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "The $RCWAxnode command is used to define the position of boundary point in each layer. It also needs to goes with the $RCWAxdiv and $RCWAperiod to define num...") |
|||
| 行 1： | 行 1： | ||
| − | The $RCWAxnode command is used to define the position of boundary point in each layer. It also needs to goes with the [[$RCWAxdiv]] and [[$RCWAperiod]] to define number of boundary point and the period of simulation domain. |
+ | The $RCWAxnode command is used to define the position of boundary point in each layer. It also needs to goes with the [[$RCWAxdiv]] and [[$RCWAperiod]] to define number of boundary point and the period of simulation domain. The left boundary point does not need to assign which automatically set as -2/period. |
於 2020年6月16日 (二) 09:53 的修訂
The $RCWAxnode command is used to define the position of boundary point in each layer. It also needs to goes with the $RCWAxdiv and $RCWAperiod to define number of boundary point and the period of simulation domain. The left boundary point does not need to assign which automatically set as -2/period.
