"$bottom efnp" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "$bottom_efnp is a command to set up the boundary condition for electron and hole fermi level. usually bottom voltage is set as zero or goes with bias of bottom volta...") |
|||
| 行 1： | 行 1： | ||
| − | $bottom_efnp is a command to set up the boundary condition for electron and hole fermi level. usually bottom voltage is set as zero or goes with bias of bottom voltage. But user can still manually define the fermi level positions. |
+ | $bottom_efnp is a command to set up the boundary condition for electron and hole fermi level. usually bottom voltage is set as zero or goes with bias of bottom voltage. But user can still manually define the fermi level positions. <br> |
| + | |||
| + | For example: <br> |
||
| + | |||
| + | $bottom_efnp |
||
| + | 2.000 3.000 |
||
| + | |||
| + | This commands set the electron and hole fermi levels at the bottom contact (right contact) to be 2.0eV and 3.0eV |
||
於 2017年8月21日 (一) 11:03 的最新修訂
$bottom_efnp is a command to set up the boundary condition for electron and hole fermi level. usually bottom voltage is set as zero or goes with bias of bottom voltage. But user can still manually define the fermi level positions.
For example:
$bottom_efnp 2.000 3.000
This commands set the electron and hole fermi levels at the bottom contact (right contact) to be 2.0eV and 3.0eV
