"$solveRE" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "$solveRE is a command to solve the multimode rate equation. The format is $solveRE rateNum1 tnum dwavefreq_num addREparint(1) ... addREparint(rateNum1) rateNum2 r...") |
|||
| 行 3： | 行 3： | ||
rateNum1 tnum dwavefreq_num addREparint(1) ... addREparint(rateNum1) |
rateNum1 tnum dwavefreq_num addREparint(1) ... addREparint(rateNum1) |
||
rateNum2 ratedt cavW cavH wavelen_center addREparReal(1) ... addREparReal(rateNum2) |
rateNum2 ratedt cavW cavH wavelen_center addREparReal(1) ... addREparReal(rateNum2) |
||
| + | rateNum1 and rateNum2 is prepared for the future if some input parameter is needed, so it can set 0 for now.<br> |
||
| + | Example: |
||
| + | $solveRE |
||
| + | 0 10000001 10 |
||
| + | 0 1.0e-12 10.0e-6 6.0e-9 1060.0e-9 |
||
於 2022年1月25日 (二) 17:23 的修訂
$solveRE is a command to solve the multimode rate equation. The format is
$solveRE rateNum1 tnum dwavefreq_num addREparint(1) ... addREparint(rateNum1) rateNum2 ratedt cavW cavH wavelen_center addREparReal(1) ... addREparReal(rateNum2)
rateNum1 and rateNum2 is prepared for the future if some input parameter is needed, so it can set 0 for now.
Example:
$solveRE 0 10000001 10 0 1.0e-12 10.0e-6 6.0e-9 1060.0e-9
