"$triregiontype" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "The $triregiontype is defining the triangular shape range's arrange method. The format is $triregiontype @type @periodnumber @period_spacing(<math>\mu m</math>...") |
|||
| 行 2： | 行 2： | ||
$triregiontype |
$triregiontype |
||
| − | @type @periodnumber @period_spacing(<math>\mu m</math> |
+ | @type @periodnumber @period_spacing(<math>\mu m</math> ) |
... |
... |
||
... repeat the number of triangular region number [[$triregionnumber$]] |
... repeat the number of triangular region number [[$triregionnumber$]] |
||
於 2017年8月21日 (一) 17:23 的修訂
The $triregiontype is defining the triangular shape range's arrange method. The format is
$triregiontype @type @periodnumber @period_spacing() ... ... repeat the number of triangular region number $triregionnumber$
@type: 1 : triangular , period along x if the periodnumber >1 11 : triangular , period along y if the periodnumber >1 2 : circular shape, period along x if the periodnumber >1 21 : circular shape, period along y if the periodnumber >1 3 : elliptic shape, period along x if the periodnumber >1 31 : elliptic shape, period along y if the periodnumber >1 4 : elliptic shape, period along x if the periodnumber >1 41 : elliptic shape, period along y if the periodnumber >1
Example
$triregionnumber 2
This means that there are two triangular regions. This command must be set after the command
$ranges. The "triregionnumber" must be smaller than the "range number".
This command needs to be set before the command before the commands $triregiontype, $triranges,
For example:
$triregionnumber 2
$triregiontype 1 1 2.0 4 5 3.0
$triranges @x1 @y1 @x2 @y2 @x3 @y3 @x1 @y1 @x2 @y2 @x3 @y3
x1,y1,x2,y2,x3,y3 are 3 vertex points of triangular
