"$addanisomobility" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "$addanisomobility is the command to replace the const mobility setting in the $parameter setting. It is used for carriers with different mobility in different direc...") |
|||
| 行 3： | 行 3： | ||
$addanisomobility |
$addanisomobility |
||
| − | <math> mu_{n,x} ~~ mu_{n,y} ~~ mu_{p,x} ~~ mu_{p,y} ~~ </math> |
+ | <math> \mu_{n,x} ~~ \mu_{n,y} ~~ \mu_{p,x} ~~ \mu_{p,y} ~~ </math> |
| − | <math> mu_{n,x} ~~ mu_{n,y} ~~ mu_{p,x} ~~ mu_{p,y} ~~ </math> |
+ | <math> \mu_{n,x} ~~ \mu_{n,y} ~~ \mu_{p,x} ~~ \mu_{p,y} ~~ </math> |
| − | <math> mu_{n,x} ~~ mu_{n,y} ~~ mu_{p,x} ~~ mu_{p,y} ~~ </math> |
+ | <math> \mu_{n,x} ~~ \mu_{n,y} ~~ \mu_{p,x} ~~ \mu_{p,y} ~~ </math> |
| − | <math> mu_{n,x} ~~ mu_{n,y} ~~ mu_{p,x} ~~ mu_{p,y} ~~ </math> |
+ | <math> \mu_{n,x} ~~ \mu_{n,y} ~~ \mu_{p,x} ~~ \mu_{p,y} ~~ </math> |
| − | <math> mu_{n,x} ~~ mu_{n,y} ~~ mu_{p,x} ~~ mu_{p,y} ~~ </math> |
+ | <math> \mu_{n,x} ~~ \mu_{n,y} ~~ \mu_{p,x} ~~ \mu_{p,y} ~~ </math> |
| − | <math> mu_{n,x} ~~ mu_{n,y} ~~ mu_{p,x} ~~ mu_{p,y} ~~ </math> |
+ | <math> \mu_{n,x} ~~ \mu_{n,y} ~~ \mu_{p,x} ~~ \mu_{p,y} ~~ </math> |
If you have n layers (regions), you need to put n lines. The mobility should not be zero. |
If you have n layers (regions), you need to put n lines. The mobility should not be zero. |
||
於 2024年8月17日 (六) 19:38 的最新修訂
$addanisomobility is the command to replace the const mobility setting in the $parameter setting. It is used for carriers with different mobility in different directions.
$addanisomobility
If you have n layers (regions), you need to put n lines. The mobility should not be zero.
