「$calcgrid」：修訂間差異
跳至導覽
跳至搜尋
Jameshuang（留言 | 貢獻） 已建立頁面，內容為 "The grid number of calculation. For example, length of device is 100nm, and we wanna set the grid size as 1A. So, we should do this. $calcgrid 1000" |
無編輯摘要 |
||
| （未顯示由 2 位使用者於中間所作的 2 次修訂） | |||
| 第1行： | 第1行： | ||
The grid number of calculation. For example, length of device is 100nm, and we wanna set the grid size as 1A. So, | The grid number of calculation. For example, length of device is 100nm, and we wanna set the grid size as 1A. So, the total grid number is equal to integer(total layer thickness / dz ) +1. In this case, it should be 1001. | ||
$calcgrid | $calcgrid | ||
1001 | |||
<big>'''The $calcgrid in GUI interface '''</big> <br> | |||
1.Press the '''Contact Setting'''.<br> | |||
2.Calculate the '''thickness of all layers'''.<br> | |||
3.Set the size of '''dz''' to adjust the total grid number.<br> | |||
[[檔案:1d_$calcgrid_fig1.jpg|1300px]] | |||
於 2024年8月24日 (六) 13:34 的最新修訂
The grid number of calculation. For example, length of device is 100nm, and we wanna set the grid size as 1A. So, the total grid number is equal to integer(total layer thickness / dz ) +1. In this case, it should be 1001.
$calcgrid 1001
The $calcgrid in GUI interface
1.Press the Contact Setting.
2.Calculate the thickness of all layers.
3.Set the size of dz to adjust the total grid number.
