「$solvethermalddcc」：修訂間差異
跳至導覽
跳至搜尋
無編輯摘要 |
無編輯摘要 |
||
| （未顯示同一使用者於中間所作的 1 次修訂） | |||
| 第3行： | 第3行： | ||
<math> heatsource = \vec{E} \cdot J </math> | <math> heatsource = \vec{E} \cdot J </math> | ||
The method to enable the ddcc would be | The method to enable the ddcc would be (1) setup DDCC to run the FET or LED or .... cases with current flowing in the device. The 2nd step is to | ||
$ifsolveheat | $ifsolveheat # This one enable thermal solver | ||
$solvethermalddcc # This one request thermnal solver to use the heat source from ddcc <math> E\cdot J </math> | |||
$Boundary # This one setup the boundary condition for the thermal solver | |||
$Boundary | |||
3 | 3 | ||
123 1 300.0 | 123 1 300.0 | ||
| 第15行： | 第15行： | ||
224 2 22.3 | 224 2 22.3 | ||
$Thermalcoe | $Thermalcoe # This one setup the thermal coefficient of each volume. Additional heatsource is 0 since we use the | ||
1 1.5 0.0 | 1 1.5 0.0 # thermal source from EJ | ||
2 1.5 0.0 | 2 1.5 0.0 | ||
3 1.5 0.0 | 3 1.5 0.0 | ||
4 1.5 0.0 | 4 1.5 0.0 | ||
related command would be : <br> | |||
[[$ifsolveheat]], [[$Boundary]], [[$Thermalcoe]], [[$heatstrainsteps]] | |||
於 2024年9月6日 (五) 06:52 的最新修訂
$solvethermalddcc enable the thermal solver to use the heat source from the DDCC solver. The heat source in each elemenent will be
The method to enable the ddcc would be (1) setup DDCC to run the FET or LED or .... cases with current flowing in the device. The 2nd step is to
$ifsolveheat # This one enable thermal solver $solvethermalddcc # This one request thermnal solver to use the heat source from ddcc
$Boundary # This one setup the boundary condition for the thermal solver 3 123 1 300.0 221 1 400.0 224 2 22.3
$Thermalcoe # This one setup the thermal coefficient of each volume. Additional heatsource is 0 since we use the 1 1.5 0.0 # thermal source from EJ 2 1.5 0.0 3 1.5 0.0 4 1.5 0.0
related command would be :
$ifsolveheat, $Boundary, $Thermalcoe, $heatstrainsteps