"$maxiterations" 修訂間的差異
出自 DDCC TCAD TOOL Manual
Jameshuang (對話 | 貢獻) (已建立頁面，內容為 "The maximum of the iteration steps to get converged. If the total solving iteration step is larger than this number then the program will stop and output the unconve...") |
|||
| (未顯示同一使用者於中間所作的 1 次修訂) | |||
| 行 6： | 行 6： | ||
This means that if the program will stop and output the results once the total iteration steps reach 3000 times. |
This means that if the program will stop and output the results once the total iteration steps reach 3000 times. |
||
| + | |||
| + | <br>'''<big><big>The $maxiterations setting in GUI interface is here</big></big>''' <br> |
||
| + | Press '''Contact Setting''' and fill in the field for the '''Max iteration steps''' as needed!<br> |
||
| + | [[檔案:2D_maxiterations_fig1.jpg|1200px]] |
||
於 2024年9月22日 (日) 23:32 的最新修訂
The maximum of the iteration steps to get converged. If the total solving iteration step is larger than this number then the program will stop and output the unconverged results.
Example
$maxiterations 3000
This means that if the program will stop and output the results once the total iteration steps reach 3000 times.
The $maxiterations setting in GUI interface is here
Press Contact Setting and fill in the field for the Max iteration steps as needed!
