"$gatebias" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "To determine the bias added to the gate contact. It should be written in one row with three numbers which represent the start of the bias voltage the end of the bia...") |
|||
| (未顯示由 2 位使用者於中間所作的 5 次修訂) | |||
| 行 8： | 行 8： | ||
This means that the bias of the gate contact will starts at 0V and increases 0.1V every step until the gate bias reached 0.4V. <br> |
This means that the bias of the gate contact will starts at 0V and increases 0.1V every step until the gate bias reached 0.4V. <br> |
||
i.e. -0.3 -0.2 -0.1 0 0.1 0.2 0.3 |
i.e. -0.3 -0.2 -0.1 0 0.1 0.2 0.3 |
||
| + | |||
| + | <big>'''The $gatebias setting for 1D-DDCC in GUI interface '''</big> <br> |
||
| + | |||
| + | [[檔案:1d_$gatebias_fig1.jpg|1300px]] |
||
| + | |||
| + | |||
| + | <big>'''The $gatebias setting for 2D-DDCC in GUI interface '''</big> <br> |
||
| + | Press '''Contact Setting''' and set up the bias of the gate contact as needed!<br> |
||
| + | [[檔案:2D_gatebias_fig1.jpg|1200px]]<br> |
||
| + | |||
| + | |||
| + | [[$drainbias]], [[$sourcebias]] |
||
於 2024年9月24日 (二) 21:56 的最新修訂
To determine the bias added to the gate contact.
It should be written in one row with three numbers which represent the start of the bias voltage the end of the bias voltage and the step size of the voltage in sequence.
For example:
$gatebias -0.3 0.3 0.1
This means that the bias of the gate contact will starts at 0V and increases 0.1V every step until the gate bias reached 0.4V.
i.e. -0.3 -0.2 -0.1 0 0.1 0.2 0.3
The $gatebias setting for 1D-DDCC in GUI interface
The $gatebias setting for 2D-DDCC in GUI interface
Press Contact Setting and set up the bias of the gate contact as needed!
