"$generation" 修訂間的差異
出自 DDCC TCAD TOOL Manual
Jameshuang (對話 | 貢獻) |
|||
| (未顯示由 1 位使用者於中間所作的 1 次修訂) | |||
| 行 9： | 行 9： | ||
This means that only the first two regions consider the generation rate which is 5.0e21 <math>cm^{-3}s^{-1}</math>. And there is no generation in the third layer. |
This means that only the first two regions consider the generation rate which is 5.0e21 <math>cm^{-3}s^{-1}</math>. And there is no generation in the third layer. |
||
| + | |||
| + | <big>'''The $generation setting for 1D-DDCC in GUI interface '''</big> <br> |
||
| + | |||
| + | '''$generation''' will only appear in the input file if '''Generation''' is pressed. <br> |
||
| + | |||
| + | [[檔案:1d_$generation_fig1.jpg|1300px]] |
||
| + | |||
| + | |||
| + | <big>'''The $generation setting for 2D-DDCC in GUI interface '''</big> <br> |
||
| + | After setting up the general structure, press '''Material Parameter''', check the box and fill in the fields as needed! |
||
| + | [[檔案:2D_generation_fig1.jpg|1300px]] |
||
於 2024年9月27日 (五) 01:08 的最新修訂
This is the generation rate of each region.
Unit
.
Example
$generation 5.0e+021 5.0e+021 0
This means that only the first two regions consider the generation rate which is 5.0e21 . And there is no generation in the third layer.
The $generation setting for 1D-DDCC in GUI interface
$generation will only appear in the input file if Generation is pressed.
The $generation setting for 2D-DDCC in GUI interface
After setting up the general structure, press Material Parameter, check the box and fill in the fields as needed!
