"$currentprecision" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "$currentprecision is the command to set the current convergence criteria. Usually the DDCC program solve the program until the error is smaller than $error. The...") |
|||
| (未顯示由 1 位使用者於中間所作的 1 次修訂) | |||
| 行 5： | 行 5： | ||
$currentprecision |
$currentprecision |
||
| + | 1.0e-3 |
||
| + | |||
| + | <big>'''The $currentprecision setting for 1D-DDCC in GUI interface '''</big> <br> |
||
| + | |||
| + | 1.Press the '''Additional Functions'''.<br> |
||
| + | 2.Press the '''Inpact Ionization'''.<br> |
||
| + | 3.Setting '''currentprecision'''.<br> |
||
| + | |||
| + | [[檔案:1d_$currentprecision_fig1.jpg|1300px]] |
||
於 2024年10月26日 (六) 12:13 的最新修訂
$currentprecision is the command to set the current convergence criteria. Usually the DDCC program solve the program until the error is smaller than $error. The $error is from the potential error where 
. However, when the currentprecission is set, the program will also request the simulation program to get current density error in each iteration smaller than the $currentprecision.
$currentprecision
$currentprecision 1.0e-3
The $currentprecision setting for 1D-DDCC in GUI interface
1.Press the Additional Functions.
2.Press the Inpact Ionization.
3.Setting currentprecision.
