"Savetimestep2D" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "$savetimestep2D is the command defining how many times steps to output the result. This command is going after the command $solvetimestep. <br> The format is <b...") |
|||
| (未顯示同一使用者於中間所作的 1 次修訂) | |||
| 行 18： | 行 18： | ||
In above cases, the total is 1 <math>\mu s</math>. The <math>\delta t</math> is 0.1ns. So the program will solve <math>10^{4}</math> steps. |
In above cases, the total is 1 <math>\mu s</math>. The <math>\delta t</math> is 0.1ns. So the program will solve <math>10^{4}</math> steps. |
||
The program will output result every 1000 steps. Totally 10 results will be output. |
The program will output result every 1000 steps. Totally 10 results will be output. |
||
| + | |||
| + | <br>'''<big><big>The $Savetimestep2D setting in GUI interface is here</big></big>''' <br> |
||
| + | After setting the command for [[$solvetimestep]], we can set the field as needed!<br> |
||
| + | [[檔案:2D_Savetimestep2D_fig1.jpg|1200px]]<br><br> |
||
Related commands: <br> |
Related commands: <br> |
||
| − | [[$solvetimestep2D]] |
||
| + | [[$solvetimestep]] |
||
於 2024年11月20日 (三) 19:49 的最新修訂
$savetimestep2D is the command defining how many times steps to output the result. This command is going after the command $solvetimestep.
The format is
$savetimestep2D steps
If steps =1, it means output those results every 
For example
$solvetimestep2D 1 2 2 1.0e-10 1.0e-6 3.00 0.1 1.0e6 0.0 $savetimestep2D 1000
In above cases, the total is 1 
. The is 0.1ns. So the program will solve 
steps.
The program will output result every 1000 steps. Totally 10 results will be output.
The $Savetimestep2D setting in GUI interface is here
After setting the command for $solvetimestep, we can set the field as needed!
Related commands:
$solvetimestep
