"$vshift" 修訂間的差異
出自 DDCC TCAD TOOL Manual
Jameshuang (對話 | 貢獻) (已建立頁面，內容為 "vshift is used to shift the reference voltage from 0 to -15v. This function is not important after we overcome the operation voltage limitation. '''<big><big>examp...") |
Jameshuang (對話 | 貢獻) |
||
| (未顯示同一使用者於中間所作的 2 次修訂) | |||
| 行 1： | 行 1： | ||
| − | vshift is used to shift the reference voltage from 0 to -15v. This function is not important after we overcome the operation voltage limitation. |
+ | $vshift is used to shift the reference voltage from 0 to -15v. This function is not important after we overcome the operation voltage limitation. |
| − | '''<big><big> |
+ | '''<big><big>Example</big></big>''' |
$vshift |
$vshift |
||
-10.0 |
-10.0 |
||
| − | This example make the reference |
+ | This example make the reference 0V to be -10.0v. But the program will shift back the voltage after the calculation is finished. |
於 2017年8月16日 (三) 03:39 的最新修訂
$vshift is used to shift the reference voltage from 0 to -15v. This function is not important after we overcome the operation voltage limitation.
Example
$vshift -10.0
This example make the reference 0V to be -10.0v. But the program will shift back the voltage after the calculation is finished.
