"$maxsteps" 修訂間的差異
出自 DDCC TCAD TOOL Manual
Jameshuang (對話 | 貢獻) |
|||
| (未顯示由 2 位使用者於中間所作的 3 次修訂) | |||
| 行 2： | 行 2： | ||
The maximum iteration step in solver if the convergence still cannot be found. |
The maximum iteration step in solver if the convergence still cannot be found. |
||
| − | <big><big>''' |
+ | <big><big>'''Format'''</big> <br /></big> |
$maxsteps |
$maxsteps |
||
1000 |
1000 |
||
The program will automatically stop iteration after 1000 steps. It will still output data and the program will go to next bias to continue the simulation. |
The program will automatically stop iteration after 1000 steps. It will still output data and the program will go to next bias to continue the simulation. |
||
| + | |||
| + | <big>'''The $maxsteps in GUI interface'''</big> <br> |
||
| + | |||
| + | [[檔案:1d_$maxsteps_fig1.jpg|1300px]] |
||
於 2024年8月24日 (六) 21:53 的最新修訂
The maximum iteration step in solver if the convergence still cannot be found.
Format
$maxsteps 1000
The program will automatically stop iteration after 1000 steps. It will still output data and the program will go to next bias to continue the simulation.
The $maxsteps in GUI interface
