"$StopCriteria" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(→Format) |
(→Example) |
||
| (未顯示同一使用者於中間所作的 1 次修訂) | |||
| 行 10： | 行 10： | ||
|| ''Type'' || ''limit'' || Description |
|| ''Type'' || ''limit'' || Description |
||
|- |
|- |
||
| − | || 1 || max of ''E''-field || The program will finish when the maximum of E-field in all region is less than <math> |
+ | || 1 || max of ''E''-field || The program will finish when the maximum of E-field in all region is less than <math> Amp \times limit </math>. |
|- |
|- |
||
|| 2 || || |
|| 2 || || |
||
| 行 25： | 行 25： | ||
2.0 |
2.0 |
||
| − | Then the program |
+ | Then the program completes as electric field < 2.0e-5. |
== '''Related commands''' == |
== '''Related commands''' == |
||
於 2019年2月20日 (三) 09:13 的最新修訂
Format
$StopCriteria type limit // where type is an integer, limit is a floating point.
Tell the program the stop criteria, i.e., when it should exit the time-stepping.
| Type | limit | Description |
| 1 | max of E-field | The program will finish when the maximum of E-field in all region is less than  .
|
| 2 |
Example
$TimeStep 1000000000 $StopCriteria 1 1.0e-5 $SourceAmp 2.0
Then the program completes as electric field < 2.0e-5.
