"$traceraypath" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "$traceraypath is the command to output the ray's path. Because recording the ray path could wast a huge space if many photons are ran. Therefore, the software will o...") |
|||
| 行 9： | 行 9： | ||
$traceraypath |
$traceraypath |
||
100 |
100 |
||
| + | |||
| + | |||
| + | <br>'''<big><big>The $traceraypath setting in GUI interface is here</big></big>''' <br> |
||
| + | Press '''Ray Tracing''', check the box, and fill in the field as needed!<br> |
||
| + | [[檔案:2D_traceraypath_fig1.jpg|1200px]] |
||
於 2024年11月20日 (三) 22:26 的最新修訂
$traceraypath is the command to output the ray's path. Because recording the ray path could wast a huge space if many photons are ran. Therefore, the software will only output certain photons.
The command is
$traceraypath N_photons
N_photons means the program save the ray path every N_photons.
For example:
$traceraypath 100
The $traceraypath setting in GUI interface is here
Press Ray Tracing, check the box, and fill in the field as needed!
