"$RCWAxdiv" 修訂間的差異
出自 DDCC TCAD TOOL Manual
| (未顯示由 2 位使用者於中間所作的 3 次修訂) | |||
| 行 1： | 行 1： | ||
The $RCWAxdiv command is used to set material boundary number in each layer. It also needs to goes with the [[$RCWAxnode]] and [[$RCWAperiod]] to define position of boundary point and the period of simulation domain. The left boundary point does not need to assign. |
The $RCWAxdiv command is used to set material boundary number in each layer. It also needs to goes with the [[$RCWAxnode]] and [[$RCWAperiod]] to define position of boundary point and the period of simulation domain. The left boundary point does not need to assign. |
||
[[檔案:RCWA2D_input.jpg]] |
[[檔案:RCWA2D_input.jpg]] |
||
| + | $RCWAxdiv<br> |
||
| + | 3 |
||
| + | 3 |
||
| + | 5 |
||
| + | 3 |
||
| + | 3 |
||
| + | ... |
||
| + | total layer |
||
| + | |||
| + | |||
| + | <br>'''<big><big>The $RCWAxdiv setting in GUI interface is here</big></big>''' <br> |
||
| + | 1. Press '''Add new layers for RCWA''' and fill in the fields as needed!<br> |
||
| + | [[檔案:2D_RCWAxdiv_fig1.jpg|1200px]]<br> |
||
| + | |||
| + | 2. The order is from bottom to top.<br> |
||
| + | [[檔案:2D_RCWAxdiv_fig2.jpg|1200px]] |
||
於 2024年11月20日 (三) 02:45 的最新修訂
The $RCWAxdiv command is used to set material boundary number in each layer. It also needs to goes with the $RCWAxnode and $RCWAperiod to define position of boundary point and the period of simulation domain. The left boundary point does not need to assign.
$RCWAxdiv
3 3 5 3 3 ... total layer
The $RCWAxdiv setting in GUI interface is here
1. Press Add new layers for RCWA and fill in the fields as needed!
2. The order is from bottom to top.
