"$ifapplyAugerofT" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "$ifapplyAugerofT is to enable the temperature-dependent Auger coefficient module with the predefined function. The function is designed for each region. So if total...") |
|||
| 行 14： | 行 14： | ||
<math> Auger-C = p1 \times (\frac{T}{p3}) ^{p2} </math> |
<math> Auger-C = p1 \times (\frac{T}{p3}) ^{p2} </math> |
||
p1: AugerC at 300K |
p1: AugerC at 300K |
||
| + | |||
| + | <big>'''The $ifapplyAugerofT setting for 1D-DDCC in GUI interface '''</big> <br> |
||
| + | |||
| + | The parameters are modified in '''Step 4'''.<br> |
||
| + | [[檔案:1d_$ifapplyAugerofT_fig1.jpg|1300px]]<br> |
||
於 2024年11月22日 (五) 18:29 的最新修訂
$ifapplyAugerofT is to enable the temperature-dependent Auger coefficient module with the predefined function. The function is designed for each region. So if total n regions are used, then you will need to set up n regions. The format is
$ifapplyAugerofT p1 p2 p3 p1 p2 p3 p1 p2 p3 ... ... ... p1 p2 p3
p1: AugerC at 300K
The $ifapplyAugerofT setting for 1D-DDCC in GUI interface
The parameters are modified in Step 4.
