"$calculatePL" 修訂間的差異
出自 DDCC TCAD TOOL Manual
| 行 15： | 行 15： | ||
$calculatePL |
$calculatePL |
||
2.3 21.0 0.015 |
2.3 21.0 0.015 |
||
| + | |||
| + | <big>'''The $calculatePL setting for 1D-DDCC in GUI interface '''</big> <br> |
||
| + | |||
| + | 1.Press the '''Schrodinger Eigen Solver'''.<br> |
||
| + | 2.Press the '''Calculate PL/EL/gain''' and setting parameters.<br> |
||
| + | |||
| + | [[檔案:1d_$calculatePL_fig1.jpg|1300px]] |
||
| + | |||
於 2024年9月27日 (五) 17:03 的最新修訂
$calculatePL is the command to calculate the emission spectrum. It will calculate the electron and hole overlap, electron and hole eigen values , using Fermi-golden rules to calculate the emission spectrum.
The format is
$calculatePL @n_r @EPP @sigma
@n_r is the refractive index of this material (active region)
@EPP (eV) is the momentum matrix element transition energy.
@sigma (eV) is the gaussian broadening factor 
Example
$calculatePL 2.3 21.0 0.015
The $calculatePL setting for 1D-DDCC in GUI interface
1.Press the Schrodinger Eigen Solver.
2.Press the Calculate PL/EL/gain and setting parameters.
(Note there was a typo of the sequence in wiki. But GUI's sequence of Epp and nr is right. This error was corrected in 5/29/2022)
