"$bottomcontactnum" 修訂間的差異
出自 DDCC TCAD TOOL Manual
Jameshuang (對話 | 貢獻) |
|||
| 行 4： | 行 4： | ||
$bottomcontactnum |
$bottomcontactnum |
||
1 |
1 |
||
| + | |||
| + | <br>'''<big><big>The $bottomcontactnum setting in GUI interface is here</big></big>''' <br> |
||
| + | 1. After setting up the general structure, press '''Set Linear Contact'''.<br> |
||
| + | [[檔案:2D_bottomcontactnum_fig1.jpg|1200px]]<br><br> |
||
| + | 2. Press '''Add new epitaxial ranges''' and set up the contact ranges, setting the Contact side to '''Bottom'''.<br> |
||
| + | [[檔案:2D_bottomcontactnum_fig2.jpg|1200px]]<br><br> |
||
| + | 3. As you can see, there is a new contact under the structure!<br> |
||
| + | [[檔案:2D_bottomcontactnum_fig3.jpg|1200px]]<br><br> |
||
於 2024年10月27日 (日) 00:57 的最新修訂
$bottomcontactnum can determine that is there a contact at the bottom?
Example
$bottomcontactnum 1
The $bottomcontactnum setting in GUI interface is here
1. After setting up the general structure, press Set Linear Contact.
2. Press Add new epitaxial ranges and set up the contact ranges, setting the Contact side to Bottom.
3. As you can see, there is a new contact under the structure!
