"@DELAY TIME (EntangleLASER)" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "*The delay time of Entanglelasers in the system. If the delay time is -1, means the delay time is depends on the situation. If @EntangleLASER_NUM is larger then...") |
|||
| (未顯示同一使用者於中間所作的 1 次修訂) | |||
| 行 1： | 行 1： | ||
| − | *The |
+ | *The passing time of Entanglelasers in the system. If [[@EntangleLASER_NUM]] is larger then one, list them separated by ",". |
*Is store as '''delay_time''' in the fortran code. |
*Is store as '''delay_time''' in the fortran code. |
||
| 行 6： | 行 6： | ||
0 |
0 |
||
| − | Which mean the system has one Entanglelaser, and its |
+ | Which mean the system has one Entanglelaser, and its passing time is 0. Note that because Entanglelaser is the source, the passing time is usually zero. |
於 2025年1月4日 (六) 17:56 的最新修訂
- The passing time of Entanglelasers in the system. If @EntangleLASER_NUM is larger then one, list them separated by ",".
- Is store as delay_time in the fortran code.
example
@DELAY_TIME 0
Which mean the system has one Entanglelaser, and its passing time is 0. Note that because Entanglelaser is the source, the passing time is usually zero.
