"$Boundary" 修訂間的差異
出自 DDCC TCAD TOOL Manual
| 行 22： | 行 22： | ||
Related links |
Related links |
||
| − | [[$Boundary]] , [[$ThermalBoundary]], [[$ifsolveheat]] |
+ | [[$Boundary]] , [[$ThermalBoundary]], [[$ifsolveheat]], [[$Thermalcoe]] |
於 2018年7月17日 (二) 16:22 的最新修訂
$Boundary orand $ThermalBoundary are the same commands. This command setup the thermal boundary of 3D thermal solver. The format is
$Boundary N_surface_number Surface_No_1 Surface_type Surface_value Surface_No_1 Surface_type Surface_value Surface_No_1 Surface_type Surface_value Surface_No_1 Surface_type Surface_value ..... ..... repeat N_surface_number
Surface_No: The gmsh surface number to set as thermal boundary Surface_type: value: 1: fix temperature boundary 2: convention boundary condition Surface_value: The coefficient at the boundary. For type 1, it is the surface potential For type=2, it is the thermal convention coeffcient
For example
$Boundary 3 123 1 300.0 221 1 400.0 224 2 22.3
Related links
$Boundary , $ThermalBoundary, $ifsolveheat, $Thermalcoe
