「$gmshsurfparameter」：修訂間差異
跳至導覽
跳至搜尋
Jameshuang（留言 | 貢獻） 已建立頁面，內容為 "This is functional when the infile is a *.msh file generated by gmesh.List the surface numbers in the gmesh file. The parameters setting is related to each surface i..." |
無編輯摘要 |
||
| 第6行： | 第6行： | ||
$gmshsurfparameter | $gmshsurfparameter | ||
15 22 24 26 20 28 | 15 22 24 26 20 28 | ||
<br>'''<big><big>The $gmshsurfparameter setting in GUI interface is here</big></big>''' <br> | |||
1. Press '''Additional Functions'''.<br> | |||
2. Press '''Set Range from the Gmsh File’’’.<br> | |||
3. Check the box for '''Use gmsh for setting material regions'''.<br> | |||
4. Press '''Load a gmsh file''' and choose the mesh file we set before.<br> | |||
5. Press ''' Import gmsh regions''' and then we can see the Gmsh Region figure as needed!<br> | |||
6. Here are the ranges we defined in the Gmsh file earlier.<br> | |||
7. Here are the regions named in sequence ,e.g., 10,20,…,50, in the Gmsh file earlier.<br> | |||
[[檔案:2D_gmshsurfparameter_fig1.jpg|1200px]] | |||
於 2024年12月26日 (四) 09:25 的修訂
This is functional when the infile is a *.msh file generated by gmesh.List the surface numbers in the gmesh file. The parameters setting is related to each surface in sequence.
Example
$gmshsurfparameter 15 22 24 26 20 28
The $gmshsurfparameter setting in GUI interface is here
1. Press Additional Functions.
2. Press Set Range from the Gmsh File’’’.
3. Check the box for Use gmsh for setting material regions.
4. Press Load a gmsh file and choose the mesh file we set before.
5. Press Import gmsh regions and then we can see the Gmsh Region figure as needed!
6. Here are the ranges we defined in the Gmsh file earlier.
7. Here are the regions named in sequence ,e.g., 10,20,…,50, in the Gmsh file earlier.
