"$ranges" 修訂間的差異
出自 DDCC TCAD TOOL Manual
Jameshuang (對話 | 貢獻) (已建立頁面，內容為 "This is to set up the range of the rectangular regions. There are four columns for each region to fill in x start point left x end point right y start point top y en...") |
Jameshuang (對話 | 貢獻) |
||
| 行 1： | 行 1： | ||
This is to set up the range of the rectangular regions. There are four columns for each region to fill in x start point left x end point right y start point top y end point bottom. <math>Unit:{\mu}m</math> |
This is to set up the range of the rectangular regions. There are four columns for each region to fill in x start point left x end point right y start point top y end point bottom. <math>Unit:{\mu}m</math> |
||
| + | |||
| + | |||
'''<big><big>Example</big></big>''' |
'''<big><big>Example</big></big>''' |
||
於 2017年8月17日 (四) 09:48 的修訂
This is to set up the range of the rectangular regions. There are four columns for each region to fill in x start point left x end point right y start point top y end point bottom. 
Example
$ranges -0.1 10.0 20.0 15.0 -0.1 10.0 15.0 0.0
This means that there are two rectangular regions. the first region covers the area which x starts from -0.1 um to 10.0 um and y starts from 15.0 um to 20.0 um. the second region covers the area which x starts from -0.1 um to 10.0 um and y starts from 0.0 um to 15.0 um.
