"$ifapplymuofT" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "$ifapplymuofT is to activate temperature dependent mobility. The formalism would be") |
|||
| 行 1： | 行 1： | ||
$ifapplymuofT is to activate temperature dependent mobility. |
$ifapplymuofT is to activate temperature dependent mobility. |
||
The formalism would be |
The formalism would be |
||
| + | $usemubydopeT is to enable the temperature and carrier density dependent mobility module with the predefined function. The function is designed for each region. |
||
| + | So if total n regions is used, then you will need to setup n regions. The format is |
||
| + | |||
| + | $ifapplymuofT |
||
| + | p1 p2 p3 p4 p5.....p6 |
||
| + | p1 p2 p3 p4 p5.....p6 |
||
| + | 1 p2 p3 p4 p5.....p6 |
||
| + | ... |
||
| + | ... |
||
| + | ... |
||
| + | Type_RN p1 p2 p3 p4 .....p6 |
||
| + | |||
| + | |||
| + | Type |
||
| + | <math> \mu_{n} = p1 \times \left(\frac{T}{p3}\right) ^{p2} </math> , and <math> \mu_{p} = p4 \times \left(\frac{T}{p6}\right) ^{p5} </math> |
||
於 2021年6月8日 (二) 12:19 的修訂
$ifapplymuofT is to activate temperature dependent mobility. The formalism would be $usemubydopeT is to enable the temperature and carrier density dependent mobility module with the predefined function. The function is designed for each region. So if total n regions is used, then you will need to setup n regions. The format is
$ifapplymuofT p1 p2 p3 p4 p5.....p6 p1 p2 p3 p4 p5.....p6 1 p2 p3 p4 p5.....p6 ... ... ... Type_RN p1 p2 p3 p4 .....p6
Type
, and
