"$yend" 修訂間的差異
出自 DDCC TCAD TOOL Manual
| 行 3： | 行 3： | ||
<big><big>'''Format</big></big>''' |
<big><big>'''Format</big></big>''' |
||
$yend |
$yend |
||
| − | yleft yright |
||
| + | ytop ybotto, |
||
<big><big>'''Parameter Explanation</big></big>''' |
<big><big>'''Parameter Explanation</big></big>''' |
||
| − | * |
+ | * ytop : The start point to consider the field dependent mobility. <math>(cm)</math> |
| − | * |
+ | * ybottom : The end point to consider the field dependent mobility. <math>(cm)</math> |
<big><big>'''Example'''</big></big> |
<big><big>'''Example'''</big></big> |
||
$yend |
$yend |
||
| − | 525.622e-04 |
||
| + | 25.6e-04 20.0e-04 |
||
| − | 525.0e-04 |
||
<br>'''<big><big>The $yend setting in GUI interface is here</big></big>''' <br> |
<br>'''<big><big>The $yend setting in GUI interface is here</big></big>''' <br> |
||
Press '''Transistor''', check the box and fill in the fields as needed!<br> |
Press '''Transistor''', check the box and fill in the fields as needed!<br> |
||
| − | [[檔案:2D_yend_fig1.jpg| |
+ | [[檔案:2D_yend_fig1.jpg|1000px]] |
於 2024年9月27日 (五) 21:24 的最新修訂
This function is to define the range in y-direction when considering the field dependent mobility.
Format
$yend ytop ybotto,
Parameter Explanation
- ytop : The start point to consider the field dependent mobility.
- ybottom : The end point to consider the field dependent mobility.
Example
$yend 25.6e-04 20.0e-04
The $yend setting in GUI interface is here
Press Transistor, check the box and fill in the fields as needed!
