"$currentprecision" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "$currentprecision is the command to set the current convergence criteria. Usually the DDCC program solve the program until the error is smaller than $error. The...") |
|||
| 行 5： | 行 5： | ||
$currentprecision |
$currentprecision |
||
| + | 1.0e-3 |
||
於 2017年8月29日 (二) 20:49 的修訂
$currentprecision is the command to set the current convergence criteria. Usually the DDCC program solve the program until the error is smaller than $error. The $error is from the potential error where 
. However, when the currentprecission is set, the program will also request the simulation program to get current density error in each iteration smaller than the $currentprecision.
$currentprecision
$currentprecision 1.0e-3
