"$CellNumber" 修訂間的差異
出自 DDCC TCAD TOOL Manual
| 行 1： | 行 1： | ||
=='''Format'''== |
=='''Format'''== |
||
| − | $TimeStep |
||
| + | $CellNumber |
||
| ⚫ | |||
| + | ''N<sub>x</sub>'' |
||
| + | ''N<sub>y</sub>'' |
||
| ⚫ | |||
| − | <font size=3>This value tells the program what the total of time steps is.</font> |
||
| + | <font size=3>This defines the total number of nodes in ''x'', ''y'', and ''z'' directions. As a result, the total number of nodes in simulation is <math>\begin{smallmatrix}{N_x \times N_y\times N_z}\end{smallmatrix}</math>.</font> |
||
=='''Example'''== |
=='''Example'''== |
||
| − | $TimeStep |
||
| + | $CellNumber |
||
| − | + | 201 |
|
| + | 201 |
||
| + | 201 |
||
| − | Then the program is going to run 500 time steps. |
||
| + | Thus, there is 201 nodes in ''x'' direction, so as the number of nodes are in ''y'' and ''z'' direction. |
||
於 2018年7月13日 (五) 09:28 的修訂
Format
$CellNumber Nx Ny Nz // where Nx, Ny, Nz are integers.
This defines the total number of nodes in x, y, and z directions. As a result, the total number of nodes in simulation is 
.
Example
$CellNumber 201 201 201
Thus, there is 201 nodes in x direction, so as the number of nodes are in y and z direction.
