「$Thermalcoe」：修訂間差異
跳至導覽
跳至搜尋
無編輯摘要 |
無編輯摘要 |
||
| 第12行： | 第12行： | ||
Volume_num Mesh volume number | Volume_num Mesh volume number | ||
kappa thermal conductive coefficient, unit cgs <math> W/(cm^{2} | kappa thermal conductive coefficient, unit cgs <math> W/(cm^{2} \cdot K)</math> | ||
heat_source: heat source, the unit is <math> Joul/s/cm^{3} </math> or <math>W/cm^{3}</math> | heat_source: heat source, the unit is <math> Joul/s/cm^{3} </math> or <math>W/cm^{3}</math> | ||
related commands | related commands | ||
[[$Thermalcoe]], [[$Boundary]] | [[$Thermalcoe]], [[$Boundary]] | ||
於 2018年7月17日 (二) 08:20 的修訂
$Thermalcoe is the command to setup the thermal related coefficients. The command is as following
If we have N volumes, the input format would be
$Thermalcoe Volume_num_1 kappa_1 heat_source Volume_num_2 kappa_2 heat_source ... ... ... ... Volume_num_N kappa_N heat_source
Volume_num Mesh volume number kappa thermal conductive coefficient, unit cgs heat_source: heat source, the unit is or
related commands
$Thermalcoe, $Boundary