"$Thermalcoe" 修訂間的差異

於 2018年7月17日 (二) 16:21 的最新修訂

$Thermalcoe is the command to setup the thermal related coefficients. The command is as following

If we have N volumes, the input format would be  

$Thermalcoe
Volume_num_1  kappa_1  heat_source
Volume_num_2  kappa_2  heat_source
...
...
... 
...
 Volume_num_N  kappa_N  heat_source

 Volume_num  Mesh volume number
 kappa thermal conductive coefficient, unit cgs  
 heat_source: heat source, the unit is   or 

related commands

$Thermalcoe, $Boundary, $ifsolveheat