"$negfsectionarea" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "$negfsectionarea is the command to setup the area of cross section.The unit is m^2.<br> Example: $negfsectionarea 8.042e-16") |
|||
| 行 1： | 行 1： | ||
| − | $negfsectionarea is the command to setup the area of cross section.The unit is m^2.<br> |
+ | $negfsectionarea is the command to setup the area of cross section for transport direction.The unit is m^2.<br> |
Example: |
Example: |
||
$negfsectionarea |
$negfsectionarea |
||
於 2018年7月24日 (二) 14:59 的修訂
$negfsectionarea is the command to setup the area of cross section for transport direction.The unit is m^2.
Example:
$negfsectionarea 8.042e-16
