"$xsecysecmaxob" 修訂間的差異
出自 DDCC TCAD TOOL Manual
小 |
|||
| 行 10： | 行 10： | ||
1. Choose '''Set Linear Contact''' and set up your Linear Contact<br> |
1. Choose '''Set Linear Contact''' and set up your Linear Contact<br> |
||
[[檔案:2D_xsecysecmaxob_fig1.jpg|900px]]<br> |
[[檔案:2D_xsecysecmaxob_fig1.jpg|900px]]<br> |
||
| − | 2. Get Contacts!<br> |
+ | 2. Get 2 Contacts!<br> |
[[檔案:2D_xsecysecmaxob_fig2.jpg|900px]]<br> |
[[檔案:2D_xsecysecmaxob_fig2.jpg|900px]]<br> |
||
3. Press '''Mesh Setting''' and choose '''Manual mesh'''<br> |
3. Press '''Mesh Setting''' and choose '''Manual mesh'''<br> |
||
於 2024年8月20日 (二) 18:16 的修訂
This function defines the number of x-nodes, the number of y-nodes, and the number of contacts.
- Example
$xsecysecmaxob
3 5 2
It means there are 3 x-nodes, 5 y-nodes, and 2 contacts.
- The $xsecysecmaxob setting in GUI interface is here
1. Choose Set Linear Contact and set up your Linear Contact
2. Get 2 Contacts!
3. Press Mesh Setting and choose Manual mesh
4. Choose X-node point and set up your X-nodes
5. Get 3 X-nodes!
6. Repeat step 4 and set up your Y-nodes’ position!
- Related commands
- $xnode, $ynode, $xd, $xdiv, $xgradualdiv, $ygradualdiv, $ydiv,$ynode
