"$solveeigenbias" 修訂間的差異
出自 DDCC TCAD TOOL Manual
(已建立頁面，內容為 "$solveeigenbias is the command to tell program the ranges of bias to solve the eigen values. Since solving the eigen value is very time consuming, it is not suggeste...") |
(無差異)
|
於 2017年8月22日 (二) 19:42 的修訂
$solveeigenbias is the command to tell program the ranges of bias to solve the eigen values. Since solving the eigen value is very time consuming, it is not suggested to solve eigen values for all bias. Therefore, we can define the range to solve the eigen value.
Usage:
$solveeigenbias
@vg_start @vg_end @vd_start @vd_end
The program will solve eigen value when @vg_start <= vg<= @vg_end and @vd_start <= vd <= @vd_end
For example:
$solveeigenvalue $solveeigenbias 2.00 4.00 3.00 7.00 $eigensetting 30 30
The related commands are:
$solveeigenbias, $eigensetting, $usefeast, $eigencalEl
