"$xdiv" 修訂間的差異
出自 DDCC TCAD TOOL Manual
| 行 7： | 行 7： | ||
40 |
40 |
||
<br><br> |
<br><br> |
||
| + | |||
| + | <br>'''<big><big>The $xdiv setting in GUI interface is here</big></big>''' <br> |
||
| + | 1. After setting up the X-nodes, press '''Edit the nodes'''.<br> |
||
| + | 2. Choose the 1<sup>st</sup> node and set the Number of dx field to 30.<br> |
||
| + | [[檔案:2D_xdiv_fig1.jpg|1200px]]<br><br> |
||
| + | 3. We can select two nodes and set the Number of dx field to 40 at the same time.<br> |
||
| + | [[檔案:2D_xdiv_fig2.jpg|1200px]]<br><br> |
||
| + | 4. Since there is no node after node-3, there is no segment!<br> |
||
| + | [[檔案:2D_xdiv_fig3.jpg|1200px]]<br> |
||
| + | |||
| + | |||
; Ralated commands |
; Ralated commands |
||
: [[$xnode]], [[$ynode]], [[$xd]], [[$xdiv]], [[$xgradualdiv]], [[$ygradualdiv]], [[$ydiv]],[[$ynode]] |
: [[$xnode]], [[$ynode]], [[$xd]], [[$xdiv]], [[$xgradualdiv]], [[$ygradualdiv]], [[$ydiv]],[[$ynode]] |
||
於 2024年10月21日 (一) 17:19 的修訂
The number "N" of the division for x-direction in each segment.
- Format
$xdiv 30 40 40
The $xdiv setting in GUI interface is here
1. After setting up the X-nodes, press Edit the nodes.
2. Choose the 1st node and set the Number of dx field to 30.
3. We can select two nodes and set the Number of dx field to 40 at the same time.
4. Since there is no node after node-3, there is no segment!
- Ralated commands
- $xnode, $ynode, $xd, $xdiv, $xgradualdiv, $ygradualdiv, $ydiv,$ynode
